T-Knob associated with these blade holders: Upper Old Style, Upper Ultra, Lower Barrel Type and G426 Blade Holder
T-Knob used ONLY with the Lower ULTRA blade holder
Bottom Blade Holder for most older models of the Hawk Scroll Saw...
Bottom Blade Holder for Model 220VS serial numbers over 26358 and for Model 226VS serial numbers over 3107
Black plastic clip for barrel style blade holders. For older Hawk models only.
Upgrade kit for the Loc-Line Air Nozzle Assembly. Includes the following parts: Loc-line nozzle Barbed connector 5 1/2' Tubing Tubing clamp Mounting bracket 2x Grommets 2x Mounting...
Black Rubber Bellows replacement
Assortment pack of blades that comes in our rectangular "tic-tac style top" blade tubes. Includes one dozen each of 8 different blades for a total of 96 blades...
Safety Spring for the Scroll Saw arms. Safety spring that attaches to the rear of both saw arms to help prevent damage when a blade breaks.
Plastic Spring Clip for Ultra blade holders
For hand or machine sawing of wood, plastic, and fibrous materials. Skip tooth blades cut fast, provide good chip clearance, and smooth finishes. Also may out-perform metal cutting or jewelers piercing scroll saw blades...
Double tooth are easy to distinguish from skip tooth having two teeth together followed by a flat space for more efficient chip removal. Their razor sharp teeth cut faster, smoother, and more accurately in both straight and...
Top Blade Holder for Model 220VS serial numbers over 26358 and for Model 226VS serial numbers over 3107. This blade holder features a sliding pin (pictured with and without the pin inserted) and is connected directly to the...
A new design on the spiral blades. This blade has teeth cut on both sides before it is twisted. This yields an easier to control spiral blade that is long lasting. Size #2/0 & #1 recommended for softwood up to 2"...
Reverse tooth blades have skip style teeth and reverse teeth that eliminate underside tear-out and provide a smooth splinter-free finish. #2/0 recommended for softwood 1/2"-3/4" thick, wood veneer up to 3/16" thick #2...
This blade holder works for both the upper and lower holders on the G426 and the JuniorHAWK model scroll saws. This is also the lower blade holder for the BM- series saws. It comes with the 1/4x20 thumbscrew and set...
T-Knob for the Ultra Series hold down rod
F-Wrench for barrel type blade holders
Double tooth blades have 2 teeth together followed by a flat space for effective chip removal. They cut fast, leaving clean edges in wood and plastic. Gives a smooth finish. #2/0 recommended for softwood 1/2"-3/4"...
Modified geometry tooth design, minimizes burning, tolerates aggressive feed rates, expels chips extremely fast, leaves a smooth finish and cuts patterns accurately. This blade can be used successfully on soft and hard...
Loading... Please wait...
