Parts

T-Knob associated with these blade holders: Upper Old Style, Upper Ultra, Lower Barrel Type and G426 Blade Holder  

T-Knob used ONLY with the Lower ULTRA blade holder  

Bottom Blade Holder for most older models of the Hawk Scroll Saw...

Bottom Blade Holder for Model 220VS serial numbers over 26358 and for Model 226VS serial numbers over 3107

Black plastic clip for barrel style blade holders (#615-0187)

 Upgrade kit for the Loc-Line Air Nozzle Assembly. Includes the following parts: Loc-line nozzle Barbed connector 5 1/2' Tubing Tubing clamp Mounting bracket 2x Grommets 2x Mounting...

Black Rubber Bellows replacement

Safety Spring for the Scroll Saw arms. Safety spring that attaches to the rear of both saw arms to help prevent damage when a blade breaks.

Plastic Spring Clip for Ultra blade holders 

Top Blade Holder for Model 220VS serial numbers over 26358 and for Model 226VS serial numbers over 3107. This blade holder features a sliding pin (pictured with and without the pin inserted) and is connected directly to the...

This blade holder works for both the upper and lower holders on the G426 and the JuniorHAWK model scroll saws.  This is also the lower blade holder for the BM- series saws. It comes with the 1/4x20 thumbscrew and set...

T-Knob for the Ultra Series hold down rod

F-Wrench for barrel type blade holders

Includes: Tension Rod (715-1272), Cam Handle (705-0024), Round Pivot for Rear Cam Handle (715-0077), Nylon Washer (715-0103), Wedge Pivot (715-0075), Round Pivot Bottom (715-0216), 5/16-18 Nylock Nut (715-0079)...

Old style of blade holder used on 220-3 and older models. The roll pin (not shown in picture) is included.

Black Plastic Hold Down Foot. This is just the black foot. This does not include the rod, nuts, or t-knob to hold the foot in place.

Nylon washer for Rear Tension System

Set screw for any blade holder that takes the 1/4-20 T-Knob (715-0221)

Bronze bushing for the Lower Barrel Style blade holders.

Triangular Wedge Pivot for rear tensioning system