Top Blade Holder for Model 220VS serial numbers over 26358 and for Model 226VS serial numbers over 3107This blade holder features a sliding pin (pictured with and without the pin inserted) is connected directly to the upper arm of the saw using this pin as the pivot point. If your pin is locked in place, see Upper BM Blade Holder #615-1182A.
Upper blade holder
Posted by Jeff on 20th Mar 2020
Part works great. Took over a month to receive it. That’s why I have a lower rating.
Good as new
Posted by Gary Mendenhall on 18th Mar 2020
A little hard to replace , but once that was figured out the blade holder is great.
Pivot Pin VERY tight
Posted by Jon Andresen on 22nd Jul 2019
The replacement upper blade clamp that I ordered to replace the one I had been using arrived in a timely manner and looked to be an exact replacement . Upon installation I noted that the pivot pin was an interference fit to both the arm and the blade clamp. This makes the clamp nearly fixed to the arm with movement (swing front to back) VERY stiff. I also was not able to completely drive the pin flush due to the heavy press fit.
Great blade holder
Posted by Unknown on 21st May 2019
Had to replace the upper blade hold on my 20 yr old hawk saw. Part showed up quickly and after few minutes of fiddling knocked out the old roll pin and installed the new part. Oh boy did that make a difference. The only issue I had was the new pin is a bit smaller than the old one. Put a dab of lock tite on it and seems to be staying put. That’s the reason for only four stars.
I should have bought this sooner
Posted by PEGGYANNJEANNE ANDERSEN on 28th Mar 2018
I have had problems with my blade popping out of the top holder. I have also had the tip of the blade bend to the left making it very hard to put it into another hole for sawing. This part took care of all of that. Scroll sawing is now a joy again
Posted by Unknown on 11th Jul 2017
Posted by John on 13th Oct 2016
Exact fit. Fast shipping.
Upper Blade Holder
Posted by Debbie Weindorf on 6th Apr 2015
My upper blade holder wore out after 15 years. This is the same as the old and fits neatly. It was difficult to replace the old one. We had to remove the upper arm and pound out the old blade lock with a 1/8 in. punch. My husband had to do it as I did not have the strength. This is the only reason I did not give it 5 stars.
Upper Blade Holder
Posted by Shirley Worthington on 8th Sep 2014
Wore out the orginal upper blade holder after twelve years of scrolling. Idential replacement. Not the easiest to replace, but I got it done.
Upper blade holder.
Posted by Don F Helzer on 7th Feb 2014
The product is still made of a soft alum. which tend to strip the threads easily. Ours is used in a shop with many older residents and some do not know their strength. Overall the product is great if used properly.